The Pink Panther has returned! This time he's an .stl file with 4 hinge joints, 11 ball joints, and 3 sets of pop in eyes. This articulated figure can sit, stand, and hang around on his flexible hook tail. Hang him from anywhere you need a little fun and mischieviousness.
Eyes push tighly into eye holes. I use needle nose pliers to remove them firmly but carefully. Eyes are small pieces, could be a choking hazard.
Get this Retro Model this week for free before it becomes part of the Retro Models memebership plan on 12/22/23!
Print Instructions Figure prints flat on back with grid supports with the support overhang threshold set to 20%. 0.2mm Layer height 3 perimeter walls 10% gyroid infill
Tail prints without supports 0.2mm Layer height 3 perimeter walls 10% gyroid infill
Eyes color layer swap - 0.2mm Layer height 0.0mm - 10.8mm Pink 10.8mm Yellow 12.2mm Black 13.8mm Pink
Creative Commons License BY-NC-ND 4.0 A commercial license to sell these prints is available by subscribing to my Thangs Commercial Partner membership plan.